Oil Additive - Private listing - LO206 Engine Oil

Mix with your favorite oils to make chain lube, bearing lube, or engine oil.

1 ounce (28 grams) of 90nm tungsten disulfide (WS2) nano lubricant powder.

WS2 is inert. It does not change tech meters. Legal in most series. If a series bans "additives" but allows any oil, premix a bottle, remove the brand label, and run it as your oil.

Dosing (shop guidance)

• Engine oil additive (≈20 oz LO206 fill): 6 grams per treated oil change. Add on oil change 1 and 2, skip 3, add 4, skip 5, and so on.
• Chain wax / oil bath: 10 grams per 32 ounces of oil. Melt into paraffin first, then into the oil.
• DIY oil / bearing lube: 10 grams per 32 ounces of carrier oil.

Scale any batch with: grams = 10 × (ounces of oil ÷ 32). One 28-gram jar covers several treatments.

Engine oil change procedure

Warm the engine until it is hot to the hand. Shut off. Install the pull-start safety switch that says no oil. Drain. Pour in fresh oil with the WS2 mixed in (or premixed). Replace plugs. Remove the safety switch (tape or a bright handle cover so you do not forget).

Typical cycle after fill: change 1 treated (about 4 hours), change 2 treated (about 6 hours), change 3 untreated, change 4 treated, change 5 untreated.

Chain wax how-to

Full walkthrough for #219 / #35 chains (oil + paraffin bath, WS2 optional, keep oil off the clutch):

Lube the Kart Chain Before You Get to the Track

Also listed on the LO206 Resources and Downloads page.