Show All Engines, Parts, & Accessories
  • Five individual piston rings from original Honda clone ring set .030 with four dark cast iron rings one golden finish ring and visible end gaps on a white background
1 1

Honda

Original Honda Clone Ring Set .030

Original Honda Clone Ring Set .030

$23.04 USD
$23.04 USD
Sale Sold out
Shipping calculated at checkout.

This clone ring set from original Honda supplies the thin split bands that lock into piston grooves on your GX200 clone engine. Beginners see them as the parts that trap the fuel burn above the piston so power goes to the crank instead of leaking away. Experts get OEM part 13013-ZOT-801 in .030 oversize with separate top compression, secondary and oil control rings all in cast iron.

Fresh rings like these stop blow-by and bring back the compression that lets your kart pull cleanly off every corner instead of feeling flat. They are the direct match for any 196cc clone that has been bored .030 over and paired with a DJ-2298 piston.

Installation Tips: Stagger the ring end gaps 120 degrees from each other when seating them in your piston grooves then use a ring compressor to slide the assembly into the cylinder bore of your clone engine without cracking a ring or scratching the wall.
  • Oversize: .030 (.75mm)
  • Material: Cast Iron
  • OEM Part Number: 13013-ZOT-801
  • Compatible With: DJ-2298 Piston
  • Fits: GX200 Clone Engines with .030 oversize

The set delivers all three rings needed for full sealing and oil scraping so your 4-cycle kart motor makes consistent power again after the rebuild.

Will these .030 Honda clone rings fit my go-kart engine?
Yes these rings are made for GX200 clone engines with a .030 overbore and work perfectly with the DJ-2298 piston in sprint kart and dirt kart applications.
Are these rings compatible with stock or aftermarket clone engine pistons?
They are matched to the DJ-2298 .030 oversize piston and any compatible GX200 clone piston that calls for OEM Honda 13013-ZOT-801 rings in your 4-cycle kart motor.
How do I install these piston rings on my clone engine?
Expand each ring gently into the correct piston groove stagger the end gaps and employ a ring compressor when inserting the piston into the cylinder to protect the cast iron rings and achieve proper seal in your go-kart rebuild.
What warranty covers these original Honda clone rings for karting?
As genuine Honda parts these rings carry the manufacturer's warranty against defects in material and workmanship when installed correctly in your clone engine for kart racing use.

Related Products

Product Highlights

01Piston rings sit in grooves on the piston and press outward to seal combustion gases.
02This set is sized at .030 inch (0.75 mm) oversize for cylinders that have been bored larger.
03OEM Honda part number 13013-ZOT-801 matches the factory specification exactly.
04The rings work with GX200 clone engines and the DJ-2298 oversize piston.
05Cast iron construction handles the heat and friction inside a 196 cc kart engine.
06Set contains one top compression ring, one secondary ring, and oil control rings.
07Each ring has a machined end gap that allows for heat expansion once installed.
View full details
Loading reviews...

Customer Reviews

Loading reviews...